Softmagnetic Core Material | MRC Rolls
MRC Rolls for suppressing harmful interference currents, especially in use in radiated areas
New devices must be checked in accordance with the EMC directive before they can be introduced in a country of the European Union.
Electromagnetic interferences with frequencies of up to about 30 MHz tend to be conducted via cables and current paths or to be coupled between cables via inductive / capacitive mechanisms. Interference signals above 30 MHz, on the other hand, are emitted by metallic parts, components or cables that act as antennas.
In EU generally recognized frequency ranges for conducted and radiated interference:
Frequency Range (kHz)
These interferences can be suppressed or attenuated in various ways to restore compatibility with valid EMC directives (2014/30/EU).
Conducted Interferences
Power line interference and noise from switch mode power supplies are major sources of conducted EMC interference. AC power lines are the most important channel through which conducted electromagnetic interference can enter or exit equipment.
See also MRC Leaflets on Filter Cores, CMC and SoftProtector Cores:
https://mrccomponents.com/en/products/materialcore-materials/filter-cores
https://mrccomponents.com/en/products/materialcore-materials/cmc-de
https://mrccomponents.com/en/products/materialcore-materials/softprotector-cores
Radiated Interferences
Shielding prevents emitted interference signals from entering or leaving a housing. Developers can use various shielding mechanisms.
If EMC problems are only discovered later in a running project (unshielded cables have been chosen for reasons of cost or selected shielding approaches prove to be impractical) a quick and convenient solution of absorbing radiated interference is required.
MRC Components GmbH & Co. KG offers nanocrystalline rolls which suppress HF interferences and contribute to replace the expensive shielding of motor cables, easy to retrofit, to keep the required EMC limits. These rolls can be used inside housings as well as outside. They are simply attached over L1 + L2 + L3 lines (without N and PE) and absorb the harmful RF noise before it is emitted. This releases a small amount of heat that is simply dissipated to the environment. These absorbers can currently be used in engines up to approx. 1 MW.
List for the Rolls (LF):
|
||||||||||||||||||||||||||||||||||||
The information is non-binding and can be adjusted without prior information. No liability is assumend.
You have not found the right core?
Please contact us at This email address is being protected from spambots. You need JavaScript enabled to view it.
Important note: For safety and the proper usage, you are requested to approve the offered product specification for your application. These products are designed for general electronic
devices. Performance and safety of this product for applications which could lead to physical harm is not confirmed. Be sure to examine the performance and safety when the product is used
for these applications and take appropriate measures, such as failsafe, to avoid any accident. It is the responsibility of user to take such measures.